A Control
board was developed for testing the power load draw of the vehicle. The basic
component of the board consists of a motor controller, battery pack, DC/DC
controller, and power sensors. For the supercapacitor module, a Maxwell 55 F 17
V device was used. A model remote-controlled car was used for simulation. Although
the current rating is lower than actual electric vehicle, profile
characteristics are similarly depicted, which allowed for insightful analysis
of the proposed system. A vehicle without load weighs 20 kg and a vehicle with
a load weighs 30 kg. The vehicle consists of a DC permanent magnet motor, which
connects axles to all wheels with differentials. Figures 10 shows the image of
the control board and the vehicle. There were two prototype development stage
to build the control board.
Tuesday, August 4, 2020
2nd Generation EV
Monday, August 3, 2020
Vehicle Design Circuitry
Based on
concept designs, the powertrain configuration was developed for vehicle test.
The configuration can be largely divided into three sections: supercapacitor,
battery pack, and traction motor. The supercapacitor is connected to a buck booster
for constant desired voltage to the traction motor. In figure 9a, the supercapacitor
is powering the traction motor. In figure 9b, the battery pack is powering the
traction motor.
Subscribe to:
Posts (Atom)
2nd Generation EV
A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...