Wednesday, March 11, 2020

PWM for DC Motor Control

Pulse-width modulation (PWM) allows power reduction by switching the signal to on and off and breaking signals into discrete parts. A common use of PWM is for adjusting the speed of the motor or adjusting the brightness of a light source. In PWM, the duty cycle is the amount of time the switch is on to the entire period. Figure 2 shows the PWM graph changing its average voltage, which is dependent on the duty cycle. 


When including the PWM frequency, which is the amount of duty cycle per second, the output is the average voltage which takes the total area of the “on” cycle by the entire period. Ignoring qualitative PWM frequency, the average voltage is the provided voltage multiplied by the duty cycle percentage.

During a DC motor connection with the PWM, the circuit sees Ohmic resistance and inductance. In all series RL circuit, the time constant is present, which is inductance value over resistance value. T is the time it takes for the voltage to reach 1/e of the final value.

VR = V (1–1/e)

As the back EMF caused by the inductor slows down the inductance, the current of the motor is prevented from instant changes, which is a characteristic of the voltage. With this, figure 3 shows a graph of both voltage and current of a DC motor when the PWM cycle is at 50%. Green line is the voltage and purple line is the current. 




Supercapacitor Hybrid EV Series Connection Concept

Parallel connection of the battery with capacitor has been used in many power systems to reduce current ripples. In this connection, the battery and the capacitor voltage must be equal due to parallel circuit properties. This is not a large problem with most systems as the battery and the capacitor can easily achieve voltage balancing. However, supercapacitors have higher capacitance and lower voltage compared to a capacitor. Additionally, an electric vehicle battery requires a higher voltage. Therefore, it becomes increasingly difficult to achieve voltage balancing with supercapacitors in electric vehicles without adding significant mass. Also, to perform regenerative braking, a complex state-driven DC/DC power split is required. Figure 1 shows a general system design for the electric vehicle parallel configuration with the supercapacitor (SC) used in several papers. This allows for the load distribution between the battery and the supercapacitor by Kirchhoff’s current law, which reduces the battery’s current flow. The circuit uses DC/DC converters to control the voltage of the battery and supercapacitor. Another major problem with this configuration is that it is not possible to control the power flow of the supercapacitor in this configuration due to voltage balancing, which also means the supercapacitor cannot be used as a true power buffer.



Supercapacitor Series System

Another method for the hybrid system is a series connection of the battery and the supercapacitor. Impetuously, this configuration brings up several problems. Instead of current sharing, the voltage of the two power sources is combined. As the supercapacitor voltage decreases linearly over time during discharging, the average voltage supplied to the motor will decrease over time. However, the series configuration brings several advantages over the parallel system.

 

  1. There is no need to balance the voltage between the battery and the supercapacitor, which means a lower-cost supercapacitor can be used.
  2. Supercapacitor’s entire voltage range can be used to power the vehicle.
  3. Regenerative braking is simpler and low-cost.

 

In literature, there are diminutive studies into the series connection design. But when looking at current academic studies for supercapacitor hybrid systems, a good point is brought up. Most papers on this topic focus on a narrow aspect of the full power system and most results are from either mathematical or computational simulations. The increase in complexity and cost of the parallel circuit for a complete system may be the reason why most studies perform limited testing. In this paper, a practical setup of the hybrid configuration will be researched using the series configuration.


2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...