Wednesday, March 11, 2020

Supercapacitor Hybrid EV Series Connection Concept

Parallel connection of the battery with capacitor has been used in many power systems to reduce current ripples. In this connection, the battery and the capacitor voltage must be equal due to parallel circuit properties. This is not a large problem with most systems as the battery and the capacitor can easily achieve voltage balancing. However, supercapacitors have higher capacitance and lower voltage compared to a capacitor. Additionally, an electric vehicle battery requires a higher voltage. Therefore, it becomes increasingly difficult to achieve voltage balancing with supercapacitors in electric vehicles without adding significant mass. Also, to perform regenerative braking, a complex state-driven DC/DC power split is required. Figure 1 shows a general system design for the electric vehicle parallel configuration with the supercapacitor (SC) used in several papers. This allows for the load distribution between the battery and the supercapacitor by Kirchhoff’s current law, which reduces the battery’s current flow. The circuit uses DC/DC converters to control the voltage of the battery and supercapacitor. Another major problem with this configuration is that it is not possible to control the power flow of the supercapacitor in this configuration due to voltage balancing, which also means the supercapacitor cannot be used as a true power buffer.



Supercapacitor Series System

Another method for the hybrid system is a series connection of the battery and the supercapacitor. Impetuously, this configuration brings up several problems. Instead of current sharing, the voltage of the two power sources is combined. As the supercapacitor voltage decreases linearly over time during discharging, the average voltage supplied to the motor will decrease over time. However, the series configuration brings several advantages over the parallel system.

 

  1. There is no need to balance the voltage between the battery and the supercapacitor, which means a lower-cost supercapacitor can be used.
  2. Supercapacitor’s entire voltage range can be used to power the vehicle.
  3. Regenerative braking is simpler and low-cost.

 

In literature, there are diminutive studies into the series connection design. But when looking at current academic studies for supercapacitor hybrid systems, a good point is brought up. Most papers on this topic focus on a narrow aspect of the full power system and most results are from either mathematical or computational simulations. The increase in complexity and cost of the parallel circuit for a complete system may be the reason why most studies perform limited testing. In this paper, a practical setup of the hybrid configuration will be researched using the series configuration.


No comments:

Post a Comment

2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...