Wednesday, March 11, 2020

PWM for DC Motor Control

Pulse-width modulation (PWM) allows power reduction by switching the signal to on and off and breaking signals into discrete parts. A common use of PWM is for adjusting the speed of the motor or adjusting the brightness of a light source. In PWM, the duty cycle is the amount of time the switch is on to the entire period. Figure 2 shows the PWM graph changing its average voltage, which is dependent on the duty cycle. 


When including the PWM frequency, which is the amount of duty cycle per second, the output is the average voltage which takes the total area of the “on” cycle by the entire period. Ignoring qualitative PWM frequency, the average voltage is the provided voltage multiplied by the duty cycle percentage.

During a DC motor connection with the PWM, the circuit sees Ohmic resistance and inductance. In all series RL circuit, the time constant is present, which is inductance value over resistance value. T is the time it takes for the voltage to reach 1/e of the final value.

VR = V (1–1/e)

As the back EMF caused by the inductor slows down the inductance, the current of the motor is prevented from instant changes, which is a characteristic of the voltage. With this, figure 3 shows a graph of both voltage and current of a DC motor when the PWM cycle is at 50%. Green line is the voltage and purple line is the current. 




No comments:

Post a Comment

2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...