Sunday, April 12, 2020

Vehicle Testing Configuration

 Circuit configuration for the vehicle testing setup is finalized in figure 4. Instead of a diode, a MOSFET with body diode is placed, which allows for acceleration when MOSFET is off and regenerative braking when MOSFET is on. When the pulse switch is on, the battery voltage is combined with supercapacitor voltage (equation 3). When the pulse switch is off, the supercapacitor voltage is passed through the diode, excluding the battery voltage (equation 4). In the system, the average voltage will be between supercapacitor voltage and combined voltage, which will be proportional to time spent on t on in period t total.

MOSFET On: V bat + V SC           

MOSFET Off: V SC                         




The battery and supercapacitor are in series, which means the voltage are summoned. Equation 1 shows the total motor power including the armature resistance from the motor. Equation 2 distributes the power supply to each energy source. This shows as the amount of supercapacitor voltage contribution increases, the battery power contribution can decrease.

P motor = I arm (V b + VSC) – I2 arm R arm                  (1)

P motor = V b I arm + VSC I a – I2 arm R arm                (2)




No comments:

Post a Comment

2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...