To simulate an accurate power
draw of an electric vehicle, a light electric vehicle was deployed for testing.
The vehicle weighs 11.8 kg, consists of differentials, and runs four-wheel
drive using a single DC motor. Figure 7 shows the vehicle with all components.
The vehicle largely consists
of a supercapacitor (Maxwell 55 F 15 V), a battery (12 V 10 ah), and the
controller module. The supercapacitor’s voltage was altered during each testing
to see the effect of current flow to the battery.
The motor constantly received
12 V as the goal of the research is to design a configuration with constant voltage
output. The vehicle can run without supercapacitor with the bypass. When the
supercapacitor is active, the controller reads the voltage value from the supercapacitor,
which is used to control the PWM pulse rate. Equation 6 shows the PWM cycle
rate calculation based on supercapacitor voltage for the empirical testing,
which was used to program the PWM. The pulse duty updated each millisecond
based on the data retrieved from the supercapacitor voltage.
12 V = V SC + 12 V bat
( t ON / t OFF ) (6)
No comments:
Post a Comment