Monday, April 6, 2020

Series Config Mathematical Calculation

As current is proportional to torque and voltage to speed of the motor, equal voltage from battery or battery/supercapacitor results in same amount of current required to move the vehicle at a certain speed. This means when the pulse switch is on, the battery current will be equal to battery/motor system. However, as the supercapacitor covers partial amount of power during the initial acceleration, the battery is discharging at a pulse rate, which means the average of the current lower than battery/motor system. A simulation was performed with the assumption of ideal circuit to power a 12 V motor powering the electric vehicle. Initially, the supercapacitor voltage was set to 9 V and battery voltage set to 3 V. During the 10 second simulation, the supercapacitor voltage deceased to 0 V and the battery’s pulse rate increased to match the 12 V mark. 


Figure a shows the changes in system voltage. As the supercapacitor voltage decreases linearly, the battery voltage increases to match the output voltage of 12 V. Figure b shows the current draw of power sources which is not as straightforward as the voltage graph. During the initial acceleration, higher amount of torque is required to accelerate the vehicle, which results in higher current draw at the initial phase. After, the current load is decreased linearly in the simulation. Using the light electric vehicle model, initial current required was found: 21 A. Based on the battery voltage required, which is calculated using equation 5, average current was calculated with the same method as calculating the average voltage, which is the duty cycle fraction value multiplied by the total current. Without the supercapacitor, the battery current marks the blue area of the graph. With the supercapacitor, the battery current marks the green area of the graph. The simulation shows reduction in average battery voltage and current, which results in reduction in battery power required to move the vehicle during acceleration. 




No comments:

Post a Comment

2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...