Tuesday, July 14, 2020

MATLAB Simulation

     The algorithm will focus on vehicle acceleration from this point because the regenerative braking method is simple: power from the motor goes to the supercapacitor based on the supercapacitor SoC status. Also, comprehensive SoC status-based concepts have already been well established. However, because the powertrain in this research deals with vehicles with varying weight loads, the power and current profiles are different for different load weights. Therefore, the algorithm cannot rely on the same power threshold variables used in previous equations during the vehicle acceleration.

     MATLAB Simulink simulation of a 24 V electric vehicle powertrain with DC permanent motor was performed to contrast the vehicle speed and power during different load. A vehicle with no load weighs and a vehicle with additional load. The vehicle system was designed to match the vehicle for the driving test. Included are the battery pack subsystem, PWM, gearbox, differential, and vehicle body with appropriate variables. 




        A vehicle with no load achieves desiring speed in 1.4 seconds while the vehicle with load takes 5.7 seconds. The peak current and driving current for the loaded vehicle is higher with 285 A and 167 A respectively while vehicle with no load shows 247 A and 89 A for peak current and driving current, respectively.

     Graphs show vehicles with different loads take different acceleration time and current ratings. Higher load vehicle takes longer time to reach full speed (lower slope in power profile) and start with higher current ratings. The algorithm must take account of the changing vehicle current rating and acceleration time for the supercapacitor to successfully perform optimal discharge during vehicle acceleration.



No comments:

Post a Comment

2nd Generation EV

     A Control board was developed for testing the power load draw of the vehicle. The basic component of the board consists of a motor cont...